航天器运输包装箱仿真验证平台技术研究

针对数量有限的物理跑车试验无法满足减振与保温性能测试需求的问题，提出一套航天器运输包装箱动力学与热学仿真验证方法，包括：建立适用于包装箱系统的刚柔耦合多体动力学系统，通过结合线路条件测试生成的动力学系统外部激励，实现减振性能虚拟跑车测试；建立基于计算流体力学的包装箱热学模型，通过模拟自然对流和空调控制，实现包装箱保温性能虚拟跑车测试；基于C/S架构和导航式流程设计思想，建立航天器运输包装箱仿真验证平台，通过实际案例证明该平台仿真结果与实际跑车测试数据具有较高的一致性。     

Evaluation of SARAL/AltiKa performance using GNSS/IMU equipped buoy in Sajafi,Imam Hassan and Kangan Ports

Performance of SARAL/AltiKa mission has been evaluated within 2016 altimeter calibration/validation framework in Persian Gulf through three campaigns conducted in the offshore waters of Sajafi, Imam Hassan and Kangan Ports, while the altimeter overflew the passes 470, 111 and 25 on 13 Feb, 7 March and 17 June 2016, respectively. As the preparation, a lightweight buoy was equipped with a GNSS receiver/choke-ring antenna and a MEMS-based IMU to measure independent datasets in the field operations. To obtain accurate sea surface height (SSH) time series, the offset of the onboard antenna from the equilibrium sea level was predetermined through surveying operations as the buoy was deploying in the onshore waters of Kangan Port. Accordingly, the double-difference carrier phase observations have been processed via the Bernese GPS Software v. 5.0 so as to provide the GNSS-derived time series at the comparison points of the calibration campaigns, once the disturbing effects due to the platform tilt and heave have been eliminated. Owing to comparing of the SSH time series and the associating altimetry 1?Hz GDR-T datasets, the calibration/validation of the SARAL/AltiKa has been performed in the both cases of radiometer and ECMWF wet troposphere corrections so as to identify potential land contamination. An agreement of the present findings in comparison with those attained in other international calibrations sites confirms the promising feasibility of Persian Gulf as a new dedicated site for calibration/validation of ongoing and future altimetry missions.     

Assessment of between-floor structural and topological properties on cognitive map development in multilevel built environments

The present study investigated cognitive map development in multilevel built environments. Three experiments were conducted in complex virtual buildings to examine the effects of five between-floor structural factors that may impede the accuracy of humans’ ability to build multilevel cognitive maps. Results from Experiments 1 and 2 (of three experiments) revealed that difficulties in developing multilevel cognitive maps are not solely caused by the z-axis offset, as is suggested in the literature, but are due to the factorial combination of a between-floor overlap and a z-axis offset. Results from Experiment 2 showed that this process becomes substantially more difficult when the reference directions between different floors have an angular offset from each other. Finally, results from Experiment 3 demonstrated that confusing between-floor heading shifts in aligned buildings did not make it reliably harder to build multilevel cognitive maps. The implications of these findings are discussed in terms of theories of mental representations in multilayered three-dimensional spaces, as well as for architectural design.     

航天器视场遮挡分析方法研究

敏感器视场遮挡分析是航天器构型布局设计的重要组成部分，针对大型在轨变构型航天器敏感器视场遮挡分析工作量大、出错率高、遮挡率无法量化等特点，本文提出一种基于敏感器第一视角的视场遮挡快速分析方法。该方法通过设置第一视角图像蒙版及图像映射，模拟方锥形、圆锥形、球形等各类敏感器视场，通过逐个像素比对，计算视场遮挡率和遮挡方位。使用此方法建立了空间站敏感器视场遮挡分析系统，结果表明新方法能够显著提高视场遮挡分析效率和准确率，并且为机构类部件运动过程对敏感器视场遮挡的分析提供了有效工具。     

Simulating planetary wave propagation to the upper atmosphere during stratospheric warming events at different mountain wave scenarios

Parameterization schemes of atmospheric normal modes (NMs) and orographic gravity waves (OGWs) have been implemented into the mechanistic Middle and Upper Atmosphere Model (MUAM) simulating atmospheric general circulation. Based on the 12-members ensemble of runs with the MUAM, a composite of the stratospheric warming (SW) has been constructed using the UK Met Office data as the lower boundary conditions. The simulation results show that OGW amplitudes increase at altitudes above 30 km in the Northern Hemisphere after the SW event. At altitudes of about 50 km, OGWs have largest amplitudes over North American and European mountain systems before and during the composite SW, and over Himalayas after the SW. Simulations demonstrate substantial (up to 50–70%) variations of amplitudes of stationary planetary waves (PWs) during and after the SW in the mesosphere-lower thermosphere of the Northern Hemisphere. Westward travelling NMs have amplitude maxima not only in the Northern, but also in the Southern Hemisphere, where these modes have waveguides in the middle and upper atmosphere. Simulated variations of PW and NM amplitudes correspond to changes in the mean zonal wind, EP-fluxes and wave refractive index at different phases of the composite SW events. Inclusion of the parameterization of OGW effects leads to decreases in amplitudes (up to 15%) of almost all SPWs before and after the SW event and their increase (up to 40–60%) after the SW in the stratosphere and mesosphere at middle and high northern latitudes. It is suggested that observed changes in NM amplitudes in the Southern Hemisphere during SW could be caused by divergence of increased southward EP-flux. This EP-flux increases due to OGW drag before SW and extends into the Southern Hemisphere.     

叶片飞脱下转子动力学响应实验

为了研究大涵道比涡扇发动机叶片飞脱时动力学响应,更好地进行发动机安全性设计,根据相似理论设计了包含叶片飞脱装置的突加不平衡实验系统并进行了实验验证。研究结果表明:设计的突加不平衡实验系统,与某型验证机相似度高,代表性强,能够有效可控地进行突加不平衡实验,重复性好,机理清晰且飞脱不平衡量大,能够真实地模拟发动机叶片飞脱响应。通过实验发现,当大突加不平衡发生时,频谱出现超次谐波并且冲击系数由于挤压油膜阻尼器限幅作用并不呈现线性关系,因而在后续研究中还应注意限幅导致的碰摩问题。      

Geometric error analysis of an over-constrained parallel tracking mechanism using the screw theory

This paper deals with geometric error modeling and sensitivity analysis of an overconstrained parallel tracking mechanism. The main contribution is the consideration of overconstrained features that are usually ignored in previous research. The reciprocal property between a motion and a force is applied to tackle this problem in the framework of the screw theory. First of all, a nominal kinematic model of the parallel tracking mechanism is formulated. On this basis, the actual twist of the moving platform is computed through the superposition of the joint twist and geometric errors. The actuation and constrained wrenches of each limb are applied to exclude the joint displacement. After eliminating repeated errors brought by the multiplication of wrenches, a geometric error model of the parallel tracking mechanism is built. Furthermore,two sensitivity indices are defined to select essential geometric errors for future kinematic calibration. Finally, the geometric error model with minimum geometric errors is verified by simulation with SolidWorks software. Two typical poses of the parallel tracking mechanism are selected, and the differences between simulation and calculation results are very small. The results confirm the correctness and accuracy of the geometric error modeling method for over-constrained parallel mechanisms.     

ORB-SLAM系统优化框架分析概述

首先阐述了ORB-SLAM系统的核心思想和基本框架,介绍了SLAM系统中光束平差法的应用实现,然后针对视觉里程计部分不同的关键帧位姿优化过程分别进行了详细阐述,并利用KITTI数据集的不同序列的实验结果进行比较研究,给出了核心的光束平差法在ORB-SLAM中的具体工作方式及性能分析,最后讨论和分析了ORB-SLAM的优势和不足。     

Alfvén gravity waves in viscous solar plasma: Effect of the background flow

We study the Propagation and damping properties of Alfvén gravity waves in the presence of the vertical magnetic field in the viscous solar plasma under influence of the background flow by deriving a fourth order dispersion relation in terms of the Doppler shifted frequency. We derive the dispersion relation under WKB and Boussinesq approximation. We study the damping of Alfvén gravity waves for the wave frequencies less than and greater than the Brunt-Väisälä frequency. We find that the Brunt-Väisälä frequency divides the frequency ranges where the weakly or strongly damped oscillations occur. The background flow exhibits a strong effect on weakly damped oscillations and a weak effect on the strongly damped oscillations. We also notice that the damping of both the strong and weakly damped oscillations depend on the Brunt-Väisälä frequency and wave number. The effect of the background flow is also being governed by the Brunt-Väisälä frequency and wave number. We also study the properties of gravity wave mode after filtering the Alfvén wave mode by minimizing the magnetic field and noticed that the background flow shows a very strong effect on the gravity wave mode.     

面向下一代运载火箭的综合电子系统集成技术

介绍了面向下一代运载火箭分布式模块化电子系统(DIMA)的集成技术及系统架构。针对下一代运载火箭复杂电子系统的特点，按照系统集成的路线，对系统设计目标、系统功能需求分析、系统抽象机制、系统综合技术等多方面进行论述。首先，根据电气系统功能获得系统需求，采用功能抽象和层次抽象定义系统抽象模型，提取出高内聚低耦合的原子功能模块，并对模块的属性、交换关系、时序约束关系等进行定义；然后采用可视化表征方法对系统进行深入分析，利用系统综合技术实现了从系统功能到硬件资源的映射，从而给出了集成控制单元和模块的种类；随后采用分时分区的设计理念对系统节点分区划分方案及容错架构进行了定义，并对分区操作系统的调度模型和交换式的数据交互网络进行了论述，最终给出了系统软硬件架构。